Installation/Linux/foam-extend-3.0/openSUSE

1 Introduction

This page is dedicated to preparing an openSUSE system for installing the foam-extend project .

2 openSUSE versions

2.1 openSUSE 13.1

Follow these steps:

1. Switch to root mode (administrator), to install the necessary packages:

   sudo -s

   • If the 'sudo' command tells you're not in the sudoers list, then run:

     su -

2. Install the necessary packages:

   zypper install git openmpi-devel gnuplot -t pattern devel_qt4

3. Now exit from the root mode:

   exit

4. Note: In order for Open-MPI to be properly accessible, you will need to either logout and then log back in or run the following command in each terminal in the meantime:

   source /etc/profile.d/mpi-selector.sh

Then continue following the instructions on the previous page, subsection Get the source code.