Installation/Linux/foam-extend-3.0/Fedora
From OpenFOAMWiki
< Installation | Linux | foam-extend-3.0
1 Introduction
This page is dedicated to preparing a Fedora system for installing the foam-extend project .
2 Fedora versions
2.1 Fedora 19
Run the following commands:
sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz
Then continue following the instructions on the previous page, subsection Get the source code.
2.2 Fedora 20
Run the following commands:
sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel cmake wget bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz
Then continue following the instructions on the previous page, subsection Get the source code.