m (Reverted edit of Zbjudy, changed back to last version by Bgschaid) |
|||
Line 3: | Line 3: | ||
== Short description == | == Short description == | ||
− | Creates | + | Creates an axial-symmetric grid from a two-dimensional grid |
== Usage == | == Usage == | ||
Line 20: | Line 20: | ||
− | Afterwards: | + | Afterwards: uses the collapseEdges utility to remove the faces at the symmetry axis |
== Example == | == Example == |
Revision as of 12:58, 29 June 2006
1 Short description
Creates an axial-symmetric grid from a two-dimensional grid
2 Usage
Needs two inputs:
- name of the boundary that is the symmetry axis
- name of the boundary that is to be splitted into two wedge-boundaries (front and back)
Assumes the following about the grid:
- 2D-Grid (just one cell thick)
- parallel to the XY-plane
- the boundary that is the symmetry axis is a straight line
- the "front" and "back" are one patch
The type of the axis-patch is set to empty, the type of the newly created patches to wedge.
Afterwards: uses the collapseEdges utility to remove the faces at the symmetry axis
3 Example
The original mesh had (amongst others) these faces:
- center
- The face that is to be collapsed an turned into a symmetry axis (at the bottom in the picture on the left)
- frontAndBackPlanes
- The patch that contains the front and the back face and will be split into two patches)
The command
makeAxialMesh . testAxial2 center frontAndBackPlanes
converts this into the mesh seen in the picture on the right.
4 Download
The tar file with the sources. Works only for OpenFOAM 1.3.
5 History
This utility was discussed in this thread on the Message Board.
- 2006-03-28: New version which fixes a bug if the axis is not the whole length of the grid (fix provided by E David Huckaby)
Types of the newly created patches are set
- 2006-04-03: New Version that works under OpenFOAM 1.3. Removes a bug that was introduced in the last version.
--Bgschaid 14:13, 31 May 2005 (CEST)